CALL US

+91 9148155741 / 94828 34147

MAIL US

info@splta.com

FLOW TESTER

Home   Products / Flow Tester

Flow Tester CETATEST 915

The flow tester CETATEST 915 is used to measure the flow using compressed air. The device contains a measurement system consisting of a laminar flow element (LFE) and a differential pressure sensor. In the direct test method the air, provided by the internal pressure regulator, flows through the measuring section before it enters the test part. In the indirect test method the measuring section is located behind the test part. Due to the special design of the measuring section a laminar flow is generated. The resulting pressure difference is directly proportional to the volume flow.

Flow Tester CETATEST 915

Flow Tester CETATEST 915

Flow Tester CETATEST 915

Flow Tester CETATEST 915

Pressure sensor Differential pressure sensor, gauge pressure sensor (test pressure)
Pressure ranges -1,000 bar • 150 mbar • 1,000 mbar • 6 bar
Measurement range 55 ml/h to 115 l/min (depending on the laminar flow element)
Result units ml/min, ml/h, l/min, l/h, mbar*l/s
Pressure controller Mechanical
Test mode Direct or indirect test method, exponential extrapolation, bypass
Dimensions 345 mm x 145 mm x 435 mm (W x H x D)
Typical applications Tests of valves, exhaust gas systems, pipes, membranes

Flow Tester CETATEST 915-G

The CETATEST 915-G is a fully automatic flow test device for the detection of untight parts. The test is automatically started after adaption of the test part. This method of operation has been especially developed for the gas industry and for reworking in the automobile industry. The pressure drop of the laminar flow element (LFE) is measured by a differential pressure sensor and converted into a flow value.

Flow Tester CETATEST 915-G

Flow Tester CETATEST 915-G

Flow Tester CETATEST 915-G

Flow Tester CETATEST 915-G

Pressure sensors Differential pressure sensor, gauge pressure sensor (test pressure)
Pressure ranges 150 mbar • 600 mbar
Measurement range 0 to 2 ml/min resp. 0 to 120 ml/h (depending on the type of the laminar flow element)
Result units ml/min, ml/h, l/min, l/h, mbar*l/s
Pressure controller Mechanical
Test mode Leak test on flow basis
Dimensions 345 mm x 145 mm x 435 mm (W x H x D)
Typical applications Gas industry, reworking in the automobile industry